 |
上海煥堯機電設備有限公司
主營產品： 德國原裝進口工控產品,蒙特貝z92打殼機,murr /phoenix/balluff電子元器件,voltcraft實驗測試設備 |
會員.png)
聯系電話
18701975540
公司信息
- 聯系人：
- 趙正雄
- 電話：
- 86-021-68409986
- 手機：
- 18701975540
- 傳真：
- 86-021-68409986
- 地址：
- 上海市寶山區卓越時代廣場3-603A
- 郵編：
- 201800
- 個性化：
- www.hyoor.com
- 網址：
- www.hyoor.com
micronext 0939x–A雨刮器系列
2016-4-14 閱讀(2632)
=>PROTRACTOR TYPE 0939X–A
=> protractor 0939x–A
Protractor with clip
Formed of the block measurement+display on which we take up a clip which can receive most of the various types of arm ends. The device 0939x–A is supplied with standard adapters which accept most of the arm ends.
The photo opposite shows the clip with the standard adapters; the left adapter is maintained against the reference ring; The right adapter is put in the position corresponding at the arm end by means of a knurl. The tightening effort on the extremity of arm is applied through a spring blade what allows the fast change of arm by sliding simply the extremity between both adapters.
09391–A : Angle measurement device at height 20mm with clip module
delivered with a spacer for measurement at height 30mm
09392–A : Angle measurement device at height 30mm with clip module
adaptable for measurement at height 20mm
Arm with hooked end
Measure is taken with standard adapters. The clip accepts arm ends until 11 mm width.
Non hooked arm end
The plastic part covering the arm is separated from the steel arm. On each side the adapters which are mounted in clip. The blocking of the arm is made by the knurl.
Top connexion adapter
Adapters intended for this type of arm end are similar to standard adapters but executed in steel with a restricted thickness.
Adapters without dismantling
These adapters allows to make a measure without having to dismantle the extremity of this type of arm. The shape of adapters takes into account the light roundness of the sides of the arm end.
Adapter for aeroblade ( bayonet )
The adapter is a block which is put between both standard adapters. The bayonet is slid in the hole in the top. The module accepts left and right arm end. Note that this type of arm end can also be mounted with the models 09311–A and 09312–A.
Gauge for angle control
The angle gauge enables to quickly verify if the indications given by the device are in the range of admitted precision. The calibration piece is mounted on the reference ring with a low pressure and the shaft applied to the different planes of the gauge. The gauge angles are –15°, -7.5°, 0°, +7.5°, +15°. The device must indicate the angle value at +/- admitted error. The gauge can be used to calibrate the device with a precision of +/- 0.1°
